The Solution to Harmful Deposits
Engines in vehicles today are vulnerable to carbon deposits that can build up in fuel injectors, intake ports, combustion chambers and on intake valves. Even the smallest amount of carbon can produce increased exhaust emissions, reduced gas mileage, drive ability problems and engine knock. Clean fuel systems create better fuel economy. In only one tank of fuel, BG 44K® gives a total clean-up.

Ask your service representative to install BG 44K® in your gas tank today.

Found at over 15,000 locations
You won't find BG brand products and services at discount stores, they are only available from an authorized BG service centers in your are

  Problem:  Coolant is depleted of buffering      ingredients and becomes extremely corrosive, literally eating holes in cooling system components. By-products of corrosion damage, as well as rust and scale, clog the passageways that conduct the water through the radiator and choke off the flow. This may result in an overheated engine that may be damaged beyond repair.

Solution:    The entire cooling system is first cleaned and then all debris and worn out coolant is completely removed from the system. Then, fresh new premium coolant is added. Conditioners are also included to prevent rust and corrosion and BG Universal Cooling System Sealer is also included to prevent leaks.

Problem:     Brakes that squeal and grind are annoying and need to be quieted or replaced.

Solution:     First, a complete inspection is done to determine the condition of the brake pads, rotors and drums. Worn brake parts are replaced, the calipers are lubricated and a special treatment is added to the pads to prevent squealing. This service will give you peace of mind and a lot less noise every time you stop

Problem:     Heat, moisture, extreme pressure and loads cause gear oil to break down or to be contaminated, leading to lubrication failure and worn gears.

Solution:     Remove and replace old worn-out lubricant from manual transmissions, front and rear differentials, transaxles, and transfer cases. Install gear oil or the additive package required for vehicle application.

You'll experience smoother gear-shifting, quieter operation and extended component-life, which will reduce major repair costs due to worn gears.

Problem:    Over time corrosion accumulates on the battery posts and terminals to the degree that this build-up begins to drain power from the battery. That's one of the reasons battery failure is the #1 culprit for calls made requesting roadside assistance.

Solution:     A battery cleaner and leak detector is applied after a thorough cleaning and inspection. Anti-corrosion BG Battery Terminal Protectors are installed and the battery posts, terminals and case are sealed.

Problem:     Deposits accumulate in the entire diesel fuel system, including the fuel lines, injector pump, fuel injectors and combustion chambers. This causes rough idle, vibration at idle, loss of power, decreased mileage, increased smoke, slowed throttle response.

Solution:     Clean the diesel injection system with a chemical designed to remove deposits. You'll experience improved throttle response, fuel efficiency and reduced emissions.

Problem:     Condensation in your vehicle's air conditioning system promotes fungus, mold and bacterial growth that is blown into the passenger compartment. Add to this nauseating smell the sound of an A/C compressor making a clacking sound due to a depletion of oil.

Solution:     Clean out the air conditioning lines, evaporator and ventilator and then kill any bacteria mold or fungi. Then, deodorize the entire A/C system and the vehicle's interior. Finally, after a complete inspection for leaks and wear, our technicians will measure and replenish the oil in the compressor. The air inside your vehicle will be much cleaner and 4 to 5 degrees cooler, thanks to increased efficiency.

Problem:     Deposits accumulate on intake valves, injectors, ports, fuel injectors and combustion chambers causing loss of power, rough idle, hesitation, misfire, pinging, knocking, mileage and hard starting.

Solution:

• Clean fuel injectors
• Clean throttle body
• Clean plenum and air-intake
• Clean intake valves and ports
• Remove combustion chamber deposits
• Correct balance of fuel and air in system

Result:

• Reduced emissions
• Restored horsepower
• Increased fuel economy
• Starts and idles smooth and runs quieter

EGR Service

Problem:    The Exhaust Gas Recirculation (EGR) valve is clogged causing loss of power. If neglected a costly repair bill is imminent.

Solution:    Remove EGR valve and attach a specialized tool at the EGR port, where a carbon-attacking chemical eliminates carbon build-up.

Problem:     After 30,000 miles, transmission fluid begins to show its age as it turns brown in color and oxidizes due to the combination of time and heat. Deposits begin to form around the transmission's many moving parts, resulting in valves that stick and gears that slip or are sluggish and chatter as they shift.

Solution:     Rather than just removing the fluid found in the bottom of the pan, the entire transmission is cleaned and replenished with the use of special equipment. The transmission and its torque converter have all of their old contaminated fluid removed while new fluid and premium conditioners are added.

One of the hardest working parts of your vehicle will shift smoothly and effortlessly for many more trouble-free miles.